roles break after adding a new table

Topic: roles break after adding a new table (Read 1813 times) previous topic - next topic

roles break after adding a new table

September 05, 2018, 07:57:22 PM

I have roles called User and Administrator
If I go to roles and permissions it lists my 3 pages.
I created one called manufacturers. I then set the permissions and was ok. Then if I wanted to add another table called oem, it would not be listed under roles and permissions.

I even had it where I deleted a table and went back into the roles section and it still listed the table I had deleted,

Seems to be some bugs in here.

Also I found a few 404 errors when trying to access help pages on the website.

Re: roles break after adding a new table

Reply #1 – September 12, 2018, 07:53:09 PM

I believe this also happened to me. It was reported, and I believe was supposed to be fixed by v2.5.7 (which I have not tested yet).

What version are you running?

Re: roles break after adding a new table

Reply #2 – October 09, 2018, 12:16:19 PM

Confirmed (in another thread), roles are breaking in 2.5.7. I believe it has something to do with copying a page.
Roles seem to break after that point.

Re: roles break after adding a new table

Reply #3 – October 22, 2018, 06:31:22 PM

I'm using 2.5.7

I'm only trailing at moment but doesn't inspire me to buy this software if they can't fix this.
Seems quite a big bug.

Does support actually read these posts or even comment?

Re: roles break after adding a new table

Reply #4 – December 09, 2018, 03:10:30 PM

I have updated to classic 2.3 and this issue still hasn't been fixed.